Free shipping for online orders over $200 / Livraison gratuite pour les commandes en ligne de $200 et+

New Ultimaker CC Print core 0.4mm and 0.6mm

RSS
New Ultimaker CC Print core 0.4mm and 0.6mm

Introducing the Updated CC print core

Hardened Steel Nozzle Supports High-Strength Materials and New 0.4mm Nozzle Allows for Greater Detail and Enhanced Surface Finish

The print core CC 0.6, 0.4 and CC red 0.6 are specially designed to print with composite materials on the Ultimaker S5 and Ultimaker S3

The CC print core design has been updated in July 2021, whereby the CC 0.6 print core will replace the CC red 0.6 print core and a new CC 0.4 print core is introducedThe new design is more efficiently produced and features updated components that are more robust, leading to an increased reliability when using it.

Technical differences between CC cores

The CC Red 0.6 print core and the new CC 0.6 print core have the following differences

 Print core CC Red (old design) Print core CC (new design)
Brass nozzle with ruby tip Tool steel nozzle with Tin coating
Brass heater block Aluminum heater block
Steel heat break (0.15 mm thickness) Titanium heat break (0.3 mm thickness)
Aluminum heat sink with Teflon insert Aluminum heat sink without Teflon insert

Differences between CC 0.4 and CC 0.6 print cores

Additionally, a CC 0.4 print core is introduced in July 2021. The CC 0.4 print core prints with smaller line widths and by default both with 0.15 and 0.2 mm layer heights. This enables users to print composite applications with higher visual quality and smoother surface finish, while the CC 0.6 print core leads to shorter print times. With large overhang angles, the CC 0.6 print cores could produce better overhang quality.

 

Article précédent Article suivant

  • Michelle Dallas